JBX-Kernel 省電內核 for 4.2.2/4.3 GPU/CPU調節 超頻

以下適用於有刷機經驗的人，本人及作者都不承擔後果。
若失敗無法開機只要重刷ROM就可以恢復了←個人經驗-_-



由國外Hashcode, Dhacker團隊所製作的內核，功能超頻，CPU，GPU的控制，UNDERVOLTUNG選項，RAM的調整等..

CPU設置為默認的1000 MHz最大←可調到1300   最低 100

預設就很省電了，當然你可以調的更省電但可能會導致你的手機不穩定如當機等~或者你也能調快一些但這樣是不省電的。

以下為原文介紹  我英文不好就不翻了@@

Battery Friend toggle (a battery friendly mode)
Dynamic Hotplug
Optimized OPP Table for smooth CPU scaling
Frequencies: 100, 200, 300, 400, 500, 600, 700, 800, 900, 1000, 1100, 1200, 1350
Modifed Smartreflex driver (Custom Sensor for detecting n-Value).
Smartreflex Tuning Interface: Set min calibrated voltage
Smartreflex Tuning Interface: Set max calibrated voltage
Overriden trim quirks (experimental port from OMAP4460, no DCC) to override factoy defaults and reach stable overclocking up to ~1,5ghz (depends on device, each silicon is different!)
Overclocking using Live OC (mine runs stable at a maximum frequency of 1,498ghz!)
New configuration for dvfs and emif
hwmod, uart - cleanups from pre-kexec config to safe power
hwmod, uart, IRQ - Configuration for power saving
Screen off governor is hotplug: Second core will be turned off ONLY while screen is off!
CPU: lower voltages for CORE and IVA. Give CORE the abbility to scale up to higher voltage if needed
Added IVA_NITROSB
CPU: Lower voltage limit for mpu SR_MAX
PM: IVA AUTO RET relaxed workaround in idle path
Intellidemand: No hotplugging while screen is on.
Dynamic fsync control
Dynamic page-writeback
Frandom v2
JRCU / Tiny RCU
Raised voltage limits for mpu a bit
Raised the temperature limits from 64c* to 74c* (degrees)
Net: Increased IPsec/TCP Up/Down Speed
optimized CRC32 algorithm (better code generation)
mm: Page writeback interval is dynamic depending on screen state.
Optimized LZO compression
fs: asynchronus I/O latency to solid-state disk
Net: Wireless: Removed a return rule to get rid of the rx_wake/wl_wake wakelocks
CPU: policy->min set to non-static 100mhz to avoid user to be stuck at 100mhz min. Sideeffect is that you have to set the frequency lock in trickster to force the CPU to stay on your preferred min frequency, otherwise it will always jump back to 300mhz - 1000mhz.
RW Readahead 1024
Watchdogs disabled
ARM: Allow arm_memblock_steal() to remove memory from any RAM region
Devices: Deeper idle states
Increased ducati heap size
zRAM support
GPU has 3 scaling steps and OC to 416mhz
GPU: Added C4 states for Power Down mode
GPU_OC: max 416 mhz
Multicore Power Saving Mode Control
ARCH Dependant Power feature
Temp Control (Modify temperature limit for CPU/MPU)
Gamma Control
Screen/Display: Modified OMAPDSS for sharpness and lightning colors
OMAPDSS: Added variable clock rate and OPP - allows the screen to scale down power and voltage
Fsync Control: LEss IO Speed but safes you from loosing data if phone crashes
Filesystem, Android Staging, lowmemkiller: Heavy modified for R/W Speed and efficient performance
Custom Voltage Support
IO: SIOPlus, Fifo, Row, VR, Noop, Deadline, CFQ
CPU: More Governors
Deep Idle
ARM Topology
Many improvements in overall OMAP PM
SELinux patched
GREAT performance!
GREAT battery life!
Support for Ezekeel\'s \"eXperience\" App (Adds features: Music Control with Vol-Buttons, etc..)
Support for Trickster Mod Kernel Control App (Download from Gplay)

需要第三方Rom (如CM, AOKP, AOSP)  。   澳版 官方版不能刷，若刷了會開不了機

需安裝bmm照一般刷rom方式刷入即可。

若之前有刷過其他特殊內核調整請移除

停用所有CPU調整
-----------------------------------------------------------------------
JBX-Kernel-1.0 FOR 4.3 ← 目前使用正常，不會像4.2.2開不了機。
http://d-h.st/TH5


JBX-Kernel-0.8.2 FOR 4.2.2   ← 我個人刷在4.2.2系統常常會開不了機 自行決定是否刷入 。
http://d-h.st/zTr

Trickster MOD 2.4 (頻率控制)
apk.tw_Trickster MOD.apk (1.45 MB, 下載次數: 92)

2013-8-28 08:52 上傳

點擊文件名下載附件



-----------------------------------------------------------------------

登錄/註冊後可看大圖

請問Trickster 可以超GPU嗎?
還有cm10.2穩不穩?
因為現在用10.1 stable 考慮OTA 10.2
先推一下

littlepo8539 發表於 2013-8-28 12:46

                               
登錄/註冊後可看大圖

請問Trickster 可以超GPU嗎?
還有cm10.2穩不穩?
因為現在用10.1 stable 考慮OTA 10.2

Trickster 似乎沒辦法調GPU    我個人只有簡單調節 CPU
作者說可以調節
http://forum.xda-developers.com/showthread.php?t=2223517

10.2穩不穩    對我來說不會突然關機.當掉.可正常通話.音樂.WIFI.藍芽或突然很燙 就算穩@@  
我只能告訴你我使用上還蠻滿意的~

GPU Overclock
GPU Overclock does not work like Live Overclock! Custom frequencies cannot be set for the GPU,
but the maximum frequency can be selected and set from a hardcoded range.
For the GPU, the following frequencies are available:
l 154 MHz (FIXED! not visible)
l 307 MHz
l 384 MHz
l 512 MHz
The minimum frequency of 154 is FIXED and not visible!
As a result it cannot be changed since the GPU needs a minimum speed to run at. But
the kernel allows us to select the maximum speed. This can be useful for playing games
and also for saving power. For example, the GPU does not need to run at 416 MHz
when not playing games! Set it to 307 MHz in this case and save power.
Open TricksterMod and swipe to the Specific tab, where the GPU OC and its currently
set maximum frequency can be found.
Tap on it to select the preferred one:
0 = 307.2MHz
1 = 384MHz
2 = 512MHz


作者的PDF檔寫的
想超GPU的機友有福了
我也來試試
以前都用motomizer 超CPU,現在終於可以連GPU都給他超下去

使用說明
JBX Kernel_1.4.pdf (905.05 KB, 下載次數: 13)

2013-8-28 14:07 上傳

點擊文件名下載附件

littlepo8539 發表於 2013-8-28 14:01

                               
登錄/註冊後可看大圖

GPU Overclock
GPU Overclock does not work like Live Overclock! Custom frequencies cannot be set for  ...

                               
登錄/註冊後可看大圖

真的可以欸!    沒注意看Trickster   真的可以超  XD

下載來試試看

4.4要刷哪個？http://hosting.crackflasher.com/?dir=./Devs/DWiZ/Roms/Kernel/4.4
要作什麼設定？知道的朋友麻煩指點一下，謝謝

ryog 發表於 2014-3-1 01:50
4.4要刷哪個？http://hosting.crackflasher.com/?dir=./Devs/DWiZ/Roms/Kernel/4.4
要作什麼設定？知道的朋 ...

這看起來就是把更新檔留著，
所以應該找最新的日期吧...
不過我沒有刷過，留給高手解答吧~

請問紅字部份『需要第三方Rom (如CM, AOKP, AOSP) 』

是指我還要去下載其他ROM？那要哪一版？4.1？4.2？4.3？

本身提供的『JBX-Kernel-1.0 FOR 4.3』不就是4.3的ROM了嗎？

抱歉！本身是刷機初級生，只在去年8月刷成4.1.2而已...

kobe200108 發表於 2014-3-4 19:31
請問紅字部份『需要第三方Rom (如CM, AOKP, AOSP) 』

是指我還要去下載其他ROM？那要哪一版？4.1？4.2？4. ...

kernel是內核
跟rom不一樣
JBX-Kernel-1.0 FOR 4.3 是指這個內核要搭配4.3的rom
如果要第三的rom的話可以去XDA論壇找
目前大部分第三方rom都已經上到4.4