Android 台灣中文網

標題: franco.Kernel 3.0.15-r6(ISC4.0非官方內核~已翻譯)作者06/13發佈 [打印本頁]
作者: yunchenli    時間: 2012-6-14 10:10
標題: franco.Kernel 3.0.15-r6(ISC4.0非官方內核~已翻譯)作者06/13發佈
本帖最後由 yunchenli 於 2012-6-14 14:41 編輯

本文轉載自國外XDA論壇
本人親自翻譯~有關之前版本我就不在翻譯了~因為我英文程度不好~翻譯起來真的很累~
R6修正：
* All governors removed but one - pegasusq from Samsung
從三星pegasusq-移除所有調節器只保留一個

* Merged gokhanmoral work on this cpufreq driver - all credits to him. Also cleaned up a defined    but unused function
在cpu頻率驅動程序合併gokhanmorl工作-給他所有信任。此外清理已定義但未使用的功能

* fsync() calls reintroduced to match stock behavior. The device actually runs faster/smoother with this enabled - also safer for data integrity (this has nothing to do with superbrick bug)
調用fsync()重新引入匹配存取。啟用此功能後設備實際運行能更快速/流暢-對數據的完整性更穩定(這個與變磚BUG無關)

* Disable mali-400 tracking debug
禁用mali-400修正索引錯誤

* Merged two stability hotplug patches from mainline Linux kernel
從主線Linux內核合併兩個穩定熱拔插修正程序

* Added two modules to userpsace where one can see how many times the CPU was hotplugged in and hotplugged out: cat /sys/module/stand_hotplug/parameters/ cpu_up_nr and cat /sys/module/stand_hotplug/parameters/ cpu_down_nr
添加兩個補充模組到使用者區塊分別可以看到CPU熱拔插連結與斷開有多少次: cat /sys/module/stand_hotplug/parameters/ cpu_up_nr and cat /sys/module/stand_hotplug/parameters/ cpu_down_nr

* Removed overclocking at all - it was causing heat and stability issues. If you want OC use Tegrak app
移除超頻模式-這是導致發熱和穩定性問題的根源。如果你想要超頻使用Tegrak app

* Some config cleaning
清除一些設置
franco.Kernel-r6.zip (4.24 MB, 下載次數: 128)